High Geologic Slip Rates since Early Pleistocene Initiation of the San Jacinto and San Felipe Fault Zones in the San Andreas Fault System: Southern California, USA
Susanne U. JaneckePublished 2010, SCEC Contribution #1593
The San Jacinto right-lateral strike-slip fault zone is crucial for understanding plate-boundary dynamics, regional slip partitioning, and seismic hazards within the San Andreas fault system of southern California, yet its age of initiation and long-term average slip rate are controversial. This synthesis of prior and new detailed studies in the western Salton Trough documents initiation of structural segments of the San Jacinto fault zone at or slightly before the 1.07-Ma base of the Jaramillo subchron. The dextral faults changed again after ca. 0.5–0.6 Ma with creation of new fault segments and folds. There were major and widespread basinal changes in the early Pleistocene when these new faults cut across the older West Salton detachment fault. We mapped and analyzed the complex fault mesh, identifi ed structural segment boundaries along the Clark, Coyote Creek, and San Felipe fault zones, documented linkages between the major dextral faults, identifi ed previously unknown active strands of the Coyote Creek fault 5 and 8 km NE and SW of its central strands, and showed that prior analyses of these fault zones oversimplify their complexity. The Clark fault is a zone of widely distributed faulting and folding SE of the Santa Rosa Mountains and unequivocally continues 20–25 km SE of its previously inferred termination point to the San Felipe Hills. There the Clark fault zone has been deforming basinal deposits at an average dextral slip rate of 10.2 +6.9/−3.3 mm/yr for ~0.5–0.6 m.y. Five new estimates of displacement are developed here using offset successions of crystalline rocks, distinctive marker beds in the late Cenozoic basin fi ll, analysis of strike-slip–related fault-bend folds, quantifi cation of strain in folds at the tips of dextral faults, and gravity, magnetic, and geomorphic data sets. Together these show far greater right slip across the Clark fault than across either the San Felipe or Coyote Creek faults, despite the Clark fault becoming “hidden” in basinal deposits at its SE end as strain disperses onto a myriad of smaller faults, strike-slip ramps and fl ats, transrotational systems of cross faults with strongly domain patterns, and a variety of fault-fold sets. Together the Clark and Buck Ridge–Santa Rosa faults accumulated ~16.8 +3.7/−6.0 km of right separation in their lifetime near Clark Lake. The Coyote Ridge segment of the Coyote Creek fault accumulated ~3.5 ± 1.3 km since roughly 0.8– 0.9 Ma. The San Felipe fault accumulated between 4 and 12.4 km (~6.5 km preferred) of right slip on its central strands in the past 1.1–1.3 Ma at Yaqui and Pinyon ridges. Combining the estimates of displacement with ages of fault initiation indicates a lifetime geologic slip rate of 20.1 +6.4/−9.8 mm/yr across the San Jacinto fault zone (sum of Clark, Buck Ridge, and Coyote Creek faults) and about ~5.4 +5.9/−1.4 mm/yr across the San Felipe fault zone at Yaqui and Pinyon ridges. The NW Coyote Creek fault has a lifetime slip rate of ~4.1 +1.9/−2.1 mm/yr, which is a quarter of that across the Clark fault (16.0 +4.5/−9.8 mm/yr) nearby. The San Felipe fault zone is not generally regarded as an active fault in the region, yet its lifetime slip rate exceeds those of the central and southern Elsinore and the Coyote Creek fault zones. The apparent lower slip rates across the San Felipe fault in the Holocene may refl ect the transfer of strain to adjacent faults in order to bypass a contractional bend and step at Yaqui Ridge. The San Felipe, Coyote Creek, and Clark faults all show evidence of major structural adjustments after ca. 0.6–0.5 Ma, and redistribution of strain onto new rightand left-lateral faults and folds far removed from the older central fault strands. Active faults shifted their locus and main central strands by as much as 13 km in the middle Pleistocene. These changes modify the entire upper crust and were not localized in the thin sedimentary basin fi ll, which is only a few kilometers thick in most of the western Salton Trough. Steep microseismic alignments are well developed beneath most of the larger active faults and penetrate basement to the base of the seismogenic crust at 10–14 km. We hypothesize that the major structural and kinematic adjustments at ca. 0.5– 0.6 Ma resulted in major changes in slip rate within the San Jacinto and San Felipe fault zones that are likely to explain the inconsistent slip rates determined from geologic (1–0.5 m.y.; this study), paleoseismic, and geodetic studies over different time intervals. The natural evolution of complex fault zones, cross faults, block rotation, and interactions within their broad damage zones might explain all the documented and implied temporal and spatial variation in slip rates. Co-variation of slip rates among the San Jacinto, San Felipe, and San Andreas faults, while possible, is not required by the available data. Together the San Jacinto and San Felipe fault zones have accommodated ~25.5 mm/yr since their inception in early Pleistocene time, and were therefore slightly faster than the southern San Andreas fault during the same time interval. If the westward transfer of plate motion continues in southern California, the southern San Andreas fault in the Salton Trough may change from being the main plate boundary fault to defi ning the eastern margin of the growing Sierra Nevada microplate, as implied by other workers.
Citation
Janecke, S. U. (2010). High Geologic Slip Rates since Early Pleistocene Initiation of the San Jacinto and San Felipe Fault Zones in the San Andreas Fault System: Southern California, USA. GSA Special Paper 475, 475, 48. doi: 10.1130/2010.2475..
